GN-805G

GN-805G

GN-805G featuresSupport GLONASS, GPS, GALILEO, QZSS, SBAS systems (can be set to support Beidou, GPS, BEIDOU, QZSS, SBAS systems) The number of simultaneous tracking satellites is up to 25. Cold start

  • Model:: GN-805G
  • Working level:: TTL Level
  • Refresh rate:: Default 1Hz,1Hz-10Hz
  • Operating voltage(V):: DC Voltage 3.6V-5.5V, Typical: 5.0V
  • Operating current:: Capture 50mA/5.0V
  • size(mm):: 30*30*8.2mm
  • Weight(g):: 10g
  • Brand:: TOPGNSS
  • NMEA Message:: UBX,NMEA0183 RMC, VTG, GGA, GSA, GSV, GLL
  • Support customization::

GN-805G features

Support GLONASS, GPS, GALILEO, QZSS, SBAS systems (can be set to support Beidou, GPS, BEIDOU, QZSS, SBAS systems) The number of simultaneous tracking satellites is up to 25. Cold start is less than 30s; hot start is less than 2s,

  • UART/TTL interface with PPS interface

  • Support refresh rate: 10-15Hz setting, single GPS supports 20HZ output

  • Built-in 4M fLASH supports setting saving, no data loss when power off.

  • Timing accuracy: 50ns

  • Small size: 30x30x8.2mm

  • LED status indicator, you can observe the module positioning status more intuitively.

  • Strong anti-interference, anti-multipath effect

  • Superior quality and reliability

Main application of sub-meter GPS module

Car navigation, personal positioning, drone positioning, synchronization timing, track recording, data acquisition, vehicle monitoring, authorization

Detecting balloons at high altitude.

Product description

GNSS single-frequency multi-system sub-meter positioning moduleGN-805G is a high-performance, multi-system single-frequency GNSS navigation and positioning module, which can simultaneously support receiving GPS, GLONASS, GALILEO and QZSS satellite signals.There are more stars, faster positioning, and higher accuracy. The wide-area differential GPS augmentation system is supported by default. [S129,S137.... Wide-area increaseStrong Satellite].

The module has a built-in LNA low-noise amplifier and filtering, a dual-feed point antenna, and a wider bandwidth, so that the signal reception distribution is more even when receiving GNSS satellite signals, so as to achieve more stable signal reception performance and achieve high-precision positioning effects. The module is small in size and light in weight, and can be used in industrial applications such as individuals, vehicles, unmanned aerial vehicles, handheld positioning terminals, and individual positioning systems.

The GN-805G module has the application characteristics of low power consumption, high sensitivity, high precision, and low cost. It is the best choice solution to meet the navigation, positioning, timing, aircraft model and other fields, and can meet the strict application requirements of industrial grade. The GNSS module has a compact size, and the surface adopts a 1.0 6PIN connector and a pad design, which can be more convenient for integration.




TOPGNSS GNSS Module GN-805G Performance

GNSS CHIP

M8030-KT

frequency

L1, 1575.42MHz

protocol

NMEA 0183 v2.3,4.x GPS/QZSS L1 C/A,GLONASS L10F Bei Dou B1 SBAS L1 C/A:WASS,

EGNOS,MSAS , Support Galileo E1B/C. Default GPS+GLONASS mode
Default:GGA,GSA,GSV,RMC Support:VTG,GLL,TXT binary and NMEA Command

Available baud rate

(Default 9600) Can be set 1200,4800,19200,38400,57600,115200 bps

Receiving channel

72

Sensitivity

Tracking sensitivity:-160Dbm Capture sensitivity:-157dBm

Cold start

29s average

Warm start time

28s average

Hot start time

1s average

Precision

HorizontalPosition:Autonomous<2.5maverage, SBAS < 2.0m average
Velocity: 0.1 m/s
Timepulse signal: RMS 30 ns

maximum height

18000  Meter

Maximum speed

515 m/s

Maximum acceleration

4G

update frequency

1-10Hz(default1HZ

A-GPS

AssistNow on-line and off-line

Working output level

output level

Output TTL level

Physical characteristics

PIN

6 pin 1.0 pitch  GND,VCC3.3-5V.TX.RX.PPS.EN

Dimensions

30mm * 30 mm * 8.2mm

Operating Voltage

3.3V-5.0VDC ±5%

weight

8.5g

Connector form

1.0 6 PIN

Cable length:

15 CM

Operating temperature

-40 to 85

Storage temperature

-40 to 85


NMEA

Description

GND

GND

VCC

Main power supply of the system, the power supply voltage is +3.3V~+5V, and the current consumption is about 55 mA during operation.

TXDA

UART/TTL

RXDA

UART/TTL

PPS

Time standard pulse output

EN

Power enable, high level / floating module working, low level module off


首页
产品
联系