GN2336 is a high-performance dual-frequency GNSS positioning module, which is based on the state of art CYNOSURE III architecture. It supports GPS, BeiDou, GLONASS, Galileo, IRNSS, and QZSS.GN2336 integrates efficient power management architecture, while providing high precision, high sensitivity and low power consumption GNSS solutions which make it suitable for automotive navigation, fleet management, navigation applications on consumer electronics.
Supports all civil GNSS systems
Supports BDS-3 signal
Concurrent reception of L1 and L5 band signals
Smart jammer detection and suppression
Sub-meter position accuracy
Superior in multi-path mitigation and lower noise in city valley
TOPGNSS GNSS Module GN2336 Performance
NMEA 0183 v2.3,4.x GPS/QZSS L1 C/A,GLONASS L10F Bei Dou B1 SBAS L1 C/A:WASS,
EGNOS,MSAS , Support Galileo E1B/C. Default GPS+GLONASS mode
Default:GGA,GSA,GSV,RMC Support:VTG,GLL,TXT binary and NMEA Command
Available baud rate
(Default 115200) Can be set bps
Tracking sensitivity:-168Dbm Capture sensitivity:-157dBm
Warm start time
Hot start time
HorizontalPosition:Autonomous<2.5maverage, SBAS < 2.0m average
Velocity: 0.1 m/s
Timepulse signal: RMS 20 ns
Working output level
Output TTL level+USB
5 pin 2.54.pitch
36mm * 23 mm * 10.2mm
2.54 5 PIN
-40 to 85
-40 to 85
Main power supply of the system, the power supply voltage is +3.3V~+5V, and the current consumption is about 55 mA during operation.
Time standard pulse output
The new firmware supports 5HZ refresh rate setting and saving.
For specific upgrade steps, please refer to the picture operation.
New firmware upgrade and settings save 5HZ output steps：